Drive roller encoder sensor
Formatter PC board FORMATTER POWER HPGL2 SV - RC EIO WITH PC BOARD HP-GL/2 formatter PC board (Includes C7779-60270 128MB SDRAM 100MHz CL2 and firmware) formatter fits for HP Designjet Plotters fix error: 05:10
Service station - Includes wipers, pen caps, and the right hand spittoon - Installed in right side of printer
Printhead carriage assembly - Includes carriage, bushings, pen latches, carriage position sensor, and line sensor
Paper axis motor assembly - Includes cablesPaper axis motor assembly - Includes cables
Control panel assembly - Includes ribbon cable and english overlay marked with Menu Back Enter Cancel and Form feed and cut
Interconnect PC board Interconnect PC board - Installed in right-side of printer
Power supply assembly for designJet - Includes power switch. (pwr supply for copier module is Q1278-60072)
Power supply assembly - Includes power switch
Carriage (scan-axis) motor assembly - Includes cable
Service station - Service St SV - RCService station - Includes wipers, pen caps, and the right hand spittoon - Installed in right side of printer
Ink Tubes Assy 24 SV mono (black and white plotters only) for the 24-inch Designjet 500/800 printer series
Top cover assembly (Gray) - For the 24-inch DesignJet 500 printer series
Back platen assembly - Curved cover/guide that is installed below the paper drive roller - For use with 24-inch plotters
Left end cover and EIO cover (Gray) COVER WHITE (SVC) - Right cover Left end cover and EIO cover - White or Gray plastic cover on left side
Trim kit - Includes the front and back trims for the left and right sides - Installed between the main printer chassis and the left or right end covers
Control panel assembly - Includes ribbon cable and english overlay marked with Menu, Back, Enter, Cancel, and Form feed and cut
Setup printhead kit - Used to prime the ink tubes - Includes 4 setup printheads. Used to remove air and prime the ink system
Left spittoon assembly - Contains absorbers which hold excess ink from printheads
Cover kit for drive roller encoder sensor
Front platen kit - Includes platens for both the 24-inch and the 42-inch models
Ribbon cable kit - Includes installation instructions and ribbon cable with ferrite - Cable has 40 pin (F) connectors - 1.6m (5.1ft) long.
Carriage belt - Drives the carriage assembly - For use with 24-inch plotters
Formatter upgrade kit - Adds HP-GL/2 DesignJet 500 800 series GL/2 Card C7772A - Plugs into an EIO card slot. GL-2 AND RTL FORMATTER HP-GL/2 and RTL formatter PC board
DesignJet 500/800 wheel kit - Metal bar with two attached wheels - Used with the 24 inch stand only
Media deflector holders - For the DesignJet 500/800 printer series
Hewlett Packard (HP)Hub spindle blue svc cap. Cap supports roll paper, spindle takes one on each side. Part number is for one pc.
Vacuum fan assembly (OEM LIMITED SUPPLY).
Paper drive roller kit - Includes roller assembly, bushings, gear on roller, transmission gear kit, encoder disc, end thrust (axial) spring, lint free cloth, rubber glove, and instruction sheets - For use with 24-inch plotters
Formatter PC board FORMATTER POWER HPGL2 SV - RC EIO WITH PC BOARD HP-GL/2 formatter PC board (Includes C7779-60270 128MB SDRAM 100MHz CL2)
Hewlett Packard (HP)Hub spindle black svc cap. Cap supports roll paper spindle takes one on each side. Part number is for one pc.