Hard drive SATA cable - Connects the hard drive with the mother board - Transfer all the data from the printer to the hard drive
ADF jam access cover - Located on the left top side of the printer - To remove paper jam from the ADF
Right rear cover - Plastic cover located on the right rear side of the printer next to the right door assembly
40GB SATA Hard drive - 5,400 RPM, 2.5 inch form factor, 9.5mm height Hard drive kit. For PATA (Parallel ATA) connector order Q7829-67935.
Fax printed circuit assembly (PCA) - Accessed from the rear of the unit - Located on the formatter boardHP LaserJet analog fax accessory 300
Fuser Assembly - For 110 VAC - Bonds toner to paper with heat
ADF hinge - For the top cover (document lid) on the scanner (two are required)
Laser/Scanner assembly - Mounts on the support structure in the print engine frame assembly.
Laser/Scanner assembly - Mounts on the support structure in the print engine frame assembly
ADF MAINTENANCE KIT ADF maintenance kit - Includes the ADF paper pickup roller assembly and the separation pad assembly
128MB, 100-pin, DDR DIMM - Used to add flash memory-based accessory fonts, macros, and patterns
Separation pad for multipurpose tray/tray 1 assembly
Scanner controller board assembly (SCB) (main baord) - Provides timing and control for the flatbed scanner
High voltage power supply PC board - 110-127VAC input voltage
High voltage pcb 220v
High voltage power supply PC Board - 220/240VAC input voltage
Power supply PC board assembly - 110û127 VAC input voltage
Power supply PC board assembly - 220û240 VAC input voltage
Paper pickup roller assembly - For the lower cassette pickup assembly
Photo-interrupter sensor assembly (Does not include the sensor flag)
Separation block assembly - Includes separation roller assembly, springs, E-rings, separation block shaft, separation block roller, separation block holder, separation roller base, and separation roller block cover
Fusing shutter - Fuser shutter door - Closes when cartridge access door is opened
Compression spring - Electrical contact spring for toner cartridge
Bushing stop - For the fuser lever - Located on the inside upper front part of the printer - Two used
ADF input paper tray assembly - Includes the adjustable width