Carriage belt for HP DesignJet 36inch size plotters.
Right bail bracket
Media sensor mounting bracket
Cutter bushing - Connects cutter assembly to slider rod
Spindle end cap - Small core spacer - Removes for loading the media roll. Please order spindle assembly.
Pen carriage assembly - Drafting 'Head' assembly (Holds the four ink cartridges)
Control panel assembly - Includes ribbon cable
Cutter mechanism assembly - Auto cutter for rollfeed paper
Tubeaxial fan (Matsushita FBK-09A12M2-MOD) - 82.5mm (3.25in) mount hole spacing, 25.5mm (1.0in) thick, 12VDC, 35.3CFM
Overdrive gear cluster
Bail engaging lever gear
Clutch / overdrive gear assembly - Includes gear, clutch, retaining clip, and two washers
Housing assembly (on left side)
SYNTHETIC OIL (4oz Plastic Bottle) Front and Rear Slider Rods Synthetic oil - One plastic bottle of 3.5oz / 118.29 ML
DesignJet 650C service manual (English)
4MB, 80nS, 36-bit SIMM memory module - For HP Plotters, LaserJet IIISi, 4/4M, 4Si/MX and other models.
External JetDirect LAN interface module with EtherTwist (10Base-T) and ThinLAN (10Base-2) connectors
External JetDirect LAN interface module with RJ-45 connector for EtherTwist (10Base-T) or 100VG/802.12 input and three parallel (DB-25) output connectors
External JetDirect LAN interface module with EtherTwist (10Base-T) connector
'X' axis motor mount
Interconnect board
Main logic board, HP OEM DesignJet MAIN LOGIC PCA BOARD FOR 650C
JetDirect 400N modular input/output (MIO) internal print server - Provides 10/100Base-TX or 10Base-2 network connection using RJ45 or BNC connectors
External JetDirect token ring interface module with DB-9 and RJ-45 input connectors and three parallel (DB-25) output connectors
HP JetDirect 500X external token ring print server module - Interfaces up to 3 parallel printers to an ethernet 10Base-T (RJ-45), 10Base2 (BNC), or 100Base-TX (RJ-45) LAN
Primer assembly - Mounts under the service station assembly on the left side of the plotter
Idler pulley - For main drive belt
Idler drive pulley - Applies tension to the pen carriage drive belt (small belt)
Reduction pulley - Includes 2 Bearings Shaft (0.16in Diameter on Both Ends) Flange Pulley and Instructions
Ink drop reservoir - Installs on right side of plotter
Paper drive (platen) roller assembly - Long gear driven roller - Includes roller and mark encoder
SIMM module shield
Extension spring - Zinc plated music wire, 0.875in long, 0.187in OD, 0.020in wire diameter, 1.8 in/lb rate - For pen carriage drive belt pulley tensioning wedge
Extension spring - Holds the rollfeed access cover closed
Starwheel mount assembly - Includes cover, body, spring and two starwheels
Tensioning wedge (cam tensioner) - For the pen carriage drive belt pulley